To guarantee that no foreign particles remain in the pipe. Flush the pipe system before installing the flow sensors.The flow direction of the flow sensor must be respected (arrow on the flow sensor).The flow sensor must be mounted with the measuring head to the side.The flow sensor should be installed between two shut-off valves.For temperatures over 90☌ the calculator must be installed apart from the flow unit.If the danger of vibrations in the piping system exists, the calculator should be installed separately on the wall.It has to be ensured that no condensed water can run along the wires into the calculator.In general, the calculator should be installed away from the cooling pipes.Radiated heat and interfering electrical fields close to the calculator must be avoided.All wiring must be installed with a minimum distance of 300 mm from heavy voltage and high frequency cables.The cable between the flow sensor and the calculator cannot be extended.Please note that metrological parameters can no longer be changed after the calculator has been sealed. Other metrological parameters such as installation position or pulse value (Supercal 5 I only) as well as non-metrological parameters such as M-Bus address can be parameterised with the Superprog software before sealing. If it is to be used as a cooling meter or as a combined cooling/heat meter, this must be specified when ordering. The calculator is delivered as a heat meter as standard.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |